Is Mag Tech ammo good?
Thanks
.

All good for me.

I have shot a lot of it over the years, both pistol (.38 spl, 9mm), and rifle (7.62x51mm), and never a problem.

Mag Tech ammo goes bang when I pull the trigger. It leaves more carbon fouling that many brands. It's not match ammo.

I went through a 1K round case of 124gr 9mm MagTech last year. I consider it good ammo. A Shadow Systems I shot didn't like it for some reason.

For 10mm, they're one of the few companies that puts out a decent loading.

I have seen a significant amount of the 9mm load fired recently with no issues.

No complaints in 9mm or 10mm here.

No problems here with what I have shot. 38 special revolver ammo.

The .40 is stout and don’t work well in my gun. The 9mm is good.

It’s not my favorite brass case to reload otherwise I’d still use it.

I like it in 38 Super and .38 Special.

We used them for range ammo on the recreational range when I was stationed in Germany. For thee most part they ran fine in 9mm, .38, 45 and .44 from what I can recall. I can only recall one or two duds, no kabooms. I've also used them in .38 SPC and 9mm here in the states. Their 158 .38 SPC seemed a little hot last time I shot it.

I've used Magtech .380, 9mm, and 5.56. It has all been reliable and reasonably accurate.

MagTech is my preferred hunting round in my .44 mag revolver. For whatever reason it shoots the best for me (and I've shot many other mfgrs through it).

I've used a lot of 9mm and .45, no issues

Thousands of rounds in pistol ammo, 9MM and never had an issue. It’s my go to range ammo for training.

quote:

Originally posted by OKCGene:
Is Mag Tech ammo good?
Thanks
.

MagTech is one of the cheaper boxes around these parts. I've used most centerfire calibers without any issues. I enjoy the 124GR 9mm, runs flawless.

In the 2000 rounds my agency has used, I've seen two duds, but I have already had one dud in a couple of hundred Winchester training quality cartridges.

It think it is excellent in 9x19, .380 and .45 acp.

I've had good results with Magtec 9mm, .380, and 5.56. No failures or issues.

I bought a Ruger GP100 in 44 Spl that came with a factory sight in target. They used Magtech 240 gr. FMJ.