I have a chipper that has small tires on it that are flat and won't take air. So I need to get the tires and wheels of the axle. They have tin caps on them that look like they have two tabs on them. How do I remove these to get the wheels off of the axle. I do not wish to bugger the caps up. Thanks guys.
It has been a long time since I've encountered these, but I used to just pry them off, and re-use them. If they were bent enough to be chancy for re-use, a few hammer taps would generally make them compliant. Once in a while, a friction tab would snap off necessitating a replacement.
Posts: 8154 | Location: NoVA | Registered: July 22, 2009
Get you some paracord wrap a few loops in the middle of the cord around the axle behind the caps grab the ends and pull in quick hard bursts. Should be able to pop the caps off if that makes sense.
———————————————— Dark nights I wrestle with my flaws in the silence. The enemy inside me turns my thoughts into violence but higher than despair is the rock that I climb. You’re the refuge in my chaos Lord, hear my cry!!
Thanks guys, got them. Those tabs just dig in as you try to remove. Pry a little at a time, finally came off. I think I can reuse. Again, thanks for the advice.