Greetings, I have a DAO P239 in .40. I want tgo convert it to a DA/SA. From what I've seen, I need a new hammer, the decock lever and spring and the bearing piece the lever pivots on. Is it that easy?
That's correct: hammer, decocking lever, decocking lever spring, and decocking lever bearing.
Some guidance says that the sear should also be replaced when replacing a hammer, but that applies to replacing one DA/SA hammer with another DA/SA hammer. There is no reason to replace the sear when going from DAO to DA/SA.
And you can edit your original post to correct the mistake by using the little pencil and eraser icon in the middle of the three at the lower right corner of the post.
“Wise men talk because they have something to say; fools, because they have to say something.” — Plato
Posts: 50035 | Location: 10,160 Feet Above Sea Level in Commirado | Registered: April 04, 2002
