Greetings, I have a DAO P239 in .40. I want tgo convert it to a DA/SA. From what I've seen, I need a new hammer, the decock lever and spring and the bearing piece the lever pivots on. Is it that easy?
That's correct: hammer, decocking lever, decocking lever spring, and decocking lever bearing.
Some guidance says that the sear should also be replaced when replacing a hammer, but that applies to replacing one DA/SA hammer with another DA/SA hammer. There is no reason to replace the sear when going from DAO to DA/SA.
And you can edit your original post to correct the mistake by using the little pencil and eraser icon in the middle of the three at the lower right corner of the post.
“Most men … can seldom accept the simplest and most obvious truth if it … would oblige them to admit the falsity of conclusions … which they have woven, thread by thread, into the fabrics of their lives.” — Leo Tolstoy
Posts: 50141 | Location: 10,160 Feet Above Sea Level in Commirado | Registered: April 04, 2002
