Has anyone conducted any business with them? Some of their rail cuts for FSB guns are dead sexy.

quote:

Originally posted by jljones:
Has anyone conducted any business with them? Some of their rail cuts for FSB guns are dead sexy.

Jerry, did you move forward with Chop boss? I'm looking at having a barrel cut down and threaded, wondering if you have any feedback from this outfit.

I'm familiar with his work. The owner's name is Cy, he was in some groups I frequented. I haven't had contact with him in a while but I haven't heard anything negative that would change my recommendation for his work.

I have messaged him about a project in the past, but plans changed and I never ended up getting work done by him.

Just beware he's not a miracle worker and if the rail has an open slot or other geometry at the cut it's not getting filled to look like a factory length design, and he's not going to color match the anodizing when refinishing the cut. The only negative comments I can recall are people upset with the result for these two reasons.

quote:

Originally posted by MikeGLI:
Jerry, did you move forward with Chop boss? I'm looking at having a barrel cut down and threaded, wondering if you have any feedback from this outfit.

Not that you asked me, but I'd recommend Trajectory Arms for that work on an AR
https://www.trajectoryarms.com/services/