Disregard. I see it now

This video just premiered FYI

https://youtu.be/EuhKNMbPm98

I'm adding this after a bit of 'situation' tonight. I put an aftermarket plate (CH) on a MOS 45. I needed to remove the optic. I use locktite blue on all these screws and torque to the trijicon recommended value using a very high quality driver. So the supplied allen broke, an alternative drive stripped the screw even after serious heat. And ultimately I had to drill it out. That has never ever been an issue on the glock MOS trijicon screws. Worse since I really didn't like the state of the screw posts after removing the screws (probably ok but I was mad) I tried to remove the plate. Same issue. Now it completely possible that I got some bad screws. But more likely they didn't source decent stuff. In any case that's it for me on the CH plates.