SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    Disassembly of the Sig 210
Go
New
Find
Notify
Tools
Reply
  
Disassembly of the Sig 210 Login/Join 
ACP1
Member
posted
I know I am getting old but why is it so difficult to remove the breakdown pin on a P210?. If I follow the instructions the pin will not come out. I actually pull the slide all the way back and then I can get the pin out. Are the instructions simply wrong?
 
Posts: 1269 | Location: Northern Nevada | Registered: December 22, 2011Reply With QuoteReport This Post
12131
Oriental Redneck
Picture of 12131
posted Hide Post
I've always found the P210 and the CZ 75 family of pistols to be a little fussy when it comes to the takedown lever.


Q





 
Posts: 28028 | Location: TEXAS | Registered: September 04, 2008Reply With QuoteReport This Post
GaryBF
That's just the
Flomax talking
Picture of GaryBF
posted Hide Post
A general comment for any that are reading: It would be very helpful in posts like this if the author mentioned which generation P210 he was writing about. There are three: the Swiss P210, the P210 Legend, and now the P210A. I doubt that they are all the same.
 
Posts: 11875 | Location: St. Louis, Missouri | Registered: February 04, 2008Reply With QuoteReport This Post
rock185
3° that never cooled
Picture of rock185
posted Hide Post
I was lost at "breakdown pin". Had never heard the term, but I admit I don't get out muchWink


NRA Life
 
Posts: 1586 | Location: Under the Tonto Rim | Registered: August 18, 2003Reply With QuoteReport This Post
12131
Oriental Redneck
Picture of 12131
posted Hide Post
quote:
Originally posted by GaryBF:
A general comment for any that are reading: It would be very helpful in posts like this if the author mentioned which generation P210 he was writing about. There are three: the Swiss P210, the P210 Legend, and now the P210A. I doubt that they are all the same.

I've had all three, and, while they're not the same, my comment above applies to all three. Just one man's experience. Yours might be different.


Q





 
Posts: 28028 | Location: TEXAS | Registered: September 04, 2008Reply With QuoteReport This Post
drshame
Member
posted Hide Post
I've found moving the slide a bit during removal helps loosen the take-down lever/pin.
When new, it's really tight...like all the other tolerances in my 210A Target.
After a while, a few hundred rounds and a few disassemblies...it gets easier.
 
Posts: 957 | Registered: March 16, 2012Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    Disassembly of the Sig 210

© SIGforum 2024