Member posted August 14, 2017 07:10 PM
Null
This message has been edited. Last edited by: dwd1985 , June 12, 2018 08:22 AM
Member I'm assuming you are referring to a 92 . . . I have done one on a PX4 compact but I don't think it's the same setup. But I'm happy to provide pics of that if needed.
Member Posts: 2103 | Location: Semmes, Alabama | Registered: June 15, 2011
IP
Member Does it work in SA? Does the lower work fine in SA and DA with the slide off? (be sure to use your finger to dampen the hammer hitting the frame)
Member You used the wrong sized plunger and its pushing the trigger bar out
Member did you use the small plunger on both?
For real? That's weird. Can you post pics of the underside of your 92 slide?
I had no issues with my older 92F slide nor one of the TN blem complete slides.
I had an issue with a Brigadier slide not decocking so I sent it out to WAL to get installed and the right side lever deleted.
Not minority enough! Posts: 8021 | Location: Cleveland, OH | Registered: August 09, 2007
IP
JOIN, or DIE Did you remove the grips? Bump the trigger bar spring out of place?
Member Since this was a stripped slide, have you built it with the M9 slide parts to see if that configuration will work in DA?