Null

This message has been edited. Last edited by: dwd1985,

I'm assuming you are referring to a 92 . . .

I have done one on a PX4 compact but I don't think it's the same setup. But I'm happy to provide pics of that if needed.

Here's the underside of my 92FS after the G-conversion kit was installed. It works great. This about the best I can do with my camera. My 92FS is old but in excellent condition. It somehow looks rusted in my crappy photos.

Does it work in SA? Does the lower work fine in SA and DA with the slide off? (be sure to use your finger to dampen the hammer hitting the frame)

The blem slide was stripped when you bought it?
Will it function in SA?

this is the video I used. you might need to start from scratch.

https://www.youtube.com/watch?v=MiK52VzU_QE

You used the wrong sized plunger and its pushing the trigger bar out

did you use the small plunger on both?

This is making me a little crazy, since I have the same plans for a 92. Looking forward for a solution.

That's weird. Can you post pics of the underside of your 92 slide?

I had no issues with my older 92F slide nor one of the TN blem complete slides.

I had an issue with a Brigadier slide not decocking so I sent it out to WAL to get installed and the right side lever deleted.

Did you remove the grips? Bump the trigger bar spring out of place?

Since this was a stripped slide, have you built it with the M9 slide parts to see if that configuration will work in DA?