Go | New | Find | Notify | Tools | Reply | |
| Member |
Good evening all. I just picked up a older 229(circa 2008) and when I disassebled it to clean and replace springs I noticed it has a metal guide rod. Was this factory for that time or is it some aftermarket. I was eventually going to get a Gray Guns Fat guide rod. Thanks     Other things: I was going to replace the main spring. It has the newer short style, is there a Sig Factory spring available or should I just go with a Wolff one? Same for the firing pin spring. Planning in adding the Short Reach trigger and the SRT at some point as well. Any other suggestions? | ||
|
| Freethinker |
It does not look like any factory rods I have ever seen. Solid rods have been factory original at times, but the front ends do not have any sort of indentation. If the rod is drilled through (can't tell from the photo), that would not be typical of factory rods either. “ One may protest against evil; it can be exposed and, if need be, prevented by use of force. … Against stupidity we are defenseless. … [R]easons fall on deaf ears; facts that contradict one's prejudgment simply need not be believed … and when facts are irrefutable they are just pushed aside ….” — Dietrich Bonhoeffer | |||
|
| Member |
It is not drilled through or hollow from what I can tell, I will poke at it later. Definitely not hollow like a 228 guide rod. | |||
|
Now Serving 7.62 |
Older P229’s have a hollow steel guide rod, at least all I have owned. That looks a little like the Bedair Guide Rods but the Bedairs I have don’t have a hole. | |||
|
Member |
My 229s came with the hollow guide rods. Now all my Classic Sigs have Bedair guide rods. Bedair made good stuff, too bad. | |||
|
| Powered by Social Strata |
 | Please Wait. Your request is being processed... |
|
© SIGforum 2026