I drilled mine and then took a sanding disk on a dremel tool to clean the edges. I then covered the exposed metal with cold blue.
Pretty sure Brownell’s makes a specific dent raiser tool.
quote:
Originally posted by RAMIUS: How’s the socket method work? What is done?
Pretty sure you take a socket (forget what size) and you line it up in the tube and slowly hammer it into the tube the socket will push out the dimples as it passes, then pull the socket out.
———————————————— Dark nights I wrestle with my flaws in the silence. The enemy inside me turns my thoughts into violence but higher than despair is the rock that I climb. You’re the refuge in my chaos Lord, hear my cry!!
Sorry I didn’t answer earlier. This was 12 maybe 13 years ago. It was trial and error to find the right size but I took my time. I believe one of the final sockets was metric- so yes it will vary. I even used a lubricant to keep it gradual. Honestly I don’t even remember reading that I could have screwed it up so..... lucky me I guess. I usually do things myself because it’s enjoyable, not to save $. I would probably do it myself again but maybe try another method. Something fun about simplicity though and a mallet is pretty simple lol.
*****************
Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety. - Ben Franklin
Drilled & dremeled here. It was (and is) the ugliest 870 in my house to begin with, The barrel ring covers the work-- not much chance of debris finding it's way in-- and took about ten minutes, tops.