SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    ISO - bit for Mini Screwdriver Kit
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
ISO - bit for Mini Screwdriver Kit Login/Join 
xantom
McNoob
Picture of xantom
posted Hide Post
I welded a 4mm hex bit to a #2 phillips. Big Grin








"We've done four already, but now we're steady..."
 
Posts: 1925 | Location: MN | Registered: November 20, 2013Reply With QuoteReport This Post
maladat
Member
Picture of maladat
posted Hide Post
If you're going to go over the top, you could also get a 1/4" bit holder and mill the 1/4" hex shaft down to 4mm.
 
Posts: 6323 | Location: CA | Registered: January 24, 2011Reply With QuoteReport This Post
henryaz
member
Picture of henryaz
posted Hide Post
quote:
Originally posted by xantom:
Rationalizing things isn't helping me Big Grin No good explanation here, just me going on another wild goose chase.

I go on quite a few of those myself. Less so as I get older. I now just see it as an opportunity to acquire new tools. Smile


When in doubt, mumble
 
Posts: 10887 | Location: South Congress AZ | Registered: May 27, 2006Reply With QuoteReport This Post
  Powered by Social Strata Page 1 2  
 

SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    ISO - bit for Mini Screwdriver Kit

© SIGforum 2025