SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    E2 Grips P220
Go
New
Find
Notify
Tools
Reply
  
E2 Grips P220 Login/Join 
Member
posted
Is there a specific grip tool to remove
E3 Grips on a P220?
 
Posts: 7 | Registered: April 28, 2009Reply With QuoteReport This Post
Firearms Enthusiast
Picture of Mustang-PaPa
posted Hide Post
If you don't have the correct tool you can use a box end wrench. Stick it up the magwell and twist.
If memory serves me a 9/16” box end works on the single stack. If not just keep stepping up in size till you get the desired spread needed.

I have also just pushed out on one side then inserted a plastic credit card to keep the side separated then push on the other side and do the same then push the grip off.

The tools are nice but many other ways to get the grip off.
 
Posts: 18013 | Location: South West of Fort Worth, Tx. | Registered: December 26, 2008Reply With QuoteReport This Post
Member
posted Hide Post
Thanks for the Idea! I'll try it. JEL.
 
Posts: 7 | Registered: April 28, 2009Reply With QuoteReport This Post
Rebel Without a Clue
Picture of squad13
posted Hide Post
quote:
specific grip tool


If you're still stuck, drop me an email I think I have one to send you.
 
Posts: 952 | Location: Ohio | Registered: August 14, 2012Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    E2 Grips P220

© SIGforum 2024