Go | New | Find | Notify | Tools | Reply | |
SIGForum Official Hand Model |
Would the slide parts from a full sized 320 I.e striker, extractor and all other parts associated parts fit in a 3.9 inch or 3.6 inch slide? Minus the recoil/guide rod and barrel. "da evil Count Glockula."-Para | ||
|
| Freethinker |
I have purchased a variety of parts for the slide and looked at the listings for others and have seen nothing to indicate that the length of the slide makes any difference. “Most men … can seldom accept the simplest and most obvious truth if it … would oblige them to admit the falsity of conclusions … which they have woven, thread by thread, into the fabrics of their lives.” — Leo Tolstoy | |||
|
Member |
Yup. All the same. | |||
|
| Left-Handed, NOT Left-Winged! |
No difference between slide lengths, yes. But Sig has two different lengths of extractor retaining pins - the one you can see at the back of the slide. My P320c has the original shorter one, but my M17/M18's have the longer "plus" version that increases extractor tension. The ones I have bought for aftermarket slides are the original shorter ones. Sig and Midwest Gunworks have both version on their sites, so I will probably convert to the plus when they are in stock. | |||
|
| Freethinker |
Good to know. Thanks. “Most men … can seldom accept the simplest and most obvious truth if it … would oblige them to admit the falsity of conclusions … which they have woven, thread by thread, into the fabrics of their lives.” — Leo Tolstoy | |||
|
| Powered by Social Strata |
 | Please Wait. Your request is being processed... |
|
© SIGforum 2026