SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    HK p30 V3 Trigger Return Spring installation
Go
New
Find
Notify
Tools
Reply
  
HK p30 V3 Trigger Return Spring installation Login/Join 
Member
posted
I am ready to install the light trigger return spring onto my p30. I purchased it from HKParts. I can not find any instruction videos. Do I have to disassemble the entire grip module or just the pin that holds the trigger?
Any assistance is appreciated.
 
Posts: 627 | Location: San Antonio, TX | Registered: October 10, 2009Reply With QuoteReport This Post
That's just the
Flomax talking
Picture of GaryBF
posted Hide Post
Have you checked the HKRro forum Reference Library? You may find some helpful posts and photos there. I hope you also bought the special spring pliers because the trigger spring replacment can be a bitch.

https://www.hkpro.com/forum/hk-reference-library/
 
Posts: 11875 | Location: St. Louis, Missouri | Registered: February 04, 2008Reply With QuoteReport This Post
Member
posted Hide Post
Thank you Gary, I did buy the pliers and will check HKpro’s site.
P.S. I went to SLU, undergrad and Law. It has been my second home since.
 
Posts: 627 | Location: San Antonio, TX | Registered: October 10, 2009Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    HK p30 V3 Trigger Return Spring installation

© SIGforum 2024