SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    Locking insert won't align
Go
New
Find
Notify
Tools
Reply
  
Locking insert won't align Login/Join 
Member
posted
It's been awhile since I went through the armorer class. I admit I'm a bit rusty.

I have a 15 year old p228. I installed a 20 lb Wolff hammer spring and a factory short trigger. I can't get the locking insert to align properly. It is too far forward. I can't insert the takedown lever.

Any suggestions would be appreciated.
 
Posts: 6 | Registered: November 25, 2013Reply With QuoteReport This Post
Firearms Enthusiast
Picture of Mustang-PaPa
posted Hide Post
Rotate the trigger pivot pin 180* and then re insert the locking block.
 
Posts: 18016 | Location: South West of Fort Worth, Tx. | Registered: December 26, 2008Reply With QuoteReport This Post
Master-at-Arms
Picture of apf383
posted Hide Post
As Mustang said above. If you got it out, it will go back in. They are a pain in the dick though.



Foster's, Australian for Bud

 
Posts: 7489 | Location: Stuck in NY, FUAC  | Registered: November 22, 2005Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    Locking insert won't align

© SIGforum 2024