SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    walther pp grip screw?
Go
New
Find
Notify
Tools
Reply
  
walther pp grip screw? Login/Join 
ichi-go ichi-e
Picture of Underworld2086
posted
Howdy sigforum brain trust!

I want to get the proper screw driver bit for my walther pp so I don't bugger up the screw. Does anyone know the proper bit size?
 
Posts: 696 | Registered: June 24, 2003Reply With QuoteReport This Post
Member
Picture of sourdough44
posted Hide Post
If you had a ‘gunsmith’ type set or 2, couldn’t you then try a few to see what one fits best? I wouldn’t think the average grip screw is all that tight, so less critical than others.

I got a ‘fine set’ of bits from Brownells I’ve use on my Browning ‘sweet-sixteen’. This set was almost essential for some of the smaller screws. I have at least two other sets of bits.
 
Posts: 6129 | Location: WI | Registered: February 29, 2012Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    walther pp grip screw?

© SIGforum 2024