SIGforum.com    Main Page  Hop To Forum Categories  Reloading    Reloading 9mm bullets with lube groove?
Go
New
Find
Notify
Tools
Reply
  
Reloading 9mm bullets with lube groove? Login/Join 
Inject yourself!
posted
Any issues? I’m trying some Bayou 124gr bullets and I like them as they load a bit longer and still fit the CZ and Glock Gen5 barrels. 1.125 or so vs 1.10”.


https://bayoubullets.net/9mm-124-gr-rn-100-ct/


There is no issue and I’ve loaded lots at that length but I feel better at a bit longer for tolerance. It’s just my preference. No concerns. The case mount is taper crimped on the upper ridge so that’s fine.

Just double checking.

This message has been edited. Last edited by: Riley,




Do not send me to a heaven where there are no dogs.
Step Up or Stand Aside: Support the Troops !
Expectations are premeditated disappointments.
 
Posts: 8348 | Location: West | Registered: November 26, 2002Reply With QuoteReport This Post
Member
posted Hide Post
Yes, the small diameter nose with step up to the bearing surface lets you do that.
I am loading that bullet or the similar Brazos to 1.142" with plunk in all guns.

They once sent me some of the 124 without groove or step, they were blunter and had to be seated shorter.
 
Posts: 3292 | Location: Florence, Alabama, USA | Registered: July 05, 2001Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  Reloading    Reloading 9mm bullets with lube groove?

© SIGforum 2024