June 06, 2018, 11:07 AM
Black92LXAnyone using Plastixrevolution vise block?
Guess I should have asked before I ordered.
I grabbed their Pin Upper Vise block.
https://www.plastixrevolution....vise-block-black-pinNeeding to pull a flash suppressor and hope to build my 10mm upper some day after acquiring the rest of the parts and figured I would give this piece a try.
While reaction rod is the way to go my understanding is they don’t work with PCC builds.
This seemed like a better option than the cheaper plastic clamshell vice blocks I have seen.
Hoping I am not wrong but at under $20 I am not out much unless I damage an upper.
June 06, 2018, 11:46 AM
CandyMan.45As far as their stuff goes, quality made and works. As for the flash hider, I would clamp the barrel in place to remove. See if you have an old belt your not using to keep from scratching up the barrel.
June 06, 2018, 01:20 PM
BisleyblackhawkI don't have the pinned vice block...but I have this upper vice block from them...it works well and has never marred an upper (5 builds)...
https://www.plastixrevolution....-receiver-vise-blockI also have their lower magazine vice block...
IMHO Plastixrevolution makes a very good product, especially for the money...I don't think you will be disappointed at all.
June 11, 2018, 07:14 PM
Black92LXArrived.
Very well made piece. Seems to work alright so far.
June 12, 2018, 08:47 AM
striker1It looks well made. I usually just clamp the barrel in thick leather strips and twist off the hider.