Hi - I have a brand new P320 FLUX Legion and the slide only goes about halfway back when it hits a hard stop. Any ideas?

Thanks! -Brian

You’re probably going to think, “I know what I know,” but are you certain that it’s at an actual stop?

There is usually hesitation about that spot when putting the slide on a P320, and I can’t figure out why myself, but I tell people, “Just keep pushing,” and it will then overcome the hesitation and go back to where it should.

Congrats on getting your flux.

If you try inserting the slide with a different grip module, does it hit the same spot?

Are there any atypical casting areas in the flux assembly?