May 02, 2017, 04:48 PM
MWGP320 Picatinny Rail
Anyone have any issues with the first gen grip frames having a tight picatinny rail? I couldn't get the X300 off, had to disassemble it to get it off.
Tried it on my partners new (?) generation frame, with protected slide release, and it fit much smoother.
I tried a little bit of grease, but it's still pretty tight.
Any recommendations beyond getting a newer generation frame?
Thanks!
May 02, 2017, 05:00 PM
az4783054On my first 1st Generation P320c grip module my INSIGHT M6X went on easily but it was very difficult to remove. I lightly sanded the sharp edges of the rail which remedied the issue. It depends on where the bind is. You might have to lightly bevel one of the lugs of the rail if your device attaches with a cross bar as does the INSIGHT.
On my second 1st Generation P320c grip module, I experienced no such issue. I attributed it to P320 growing pains.
May 02, 2017, 07:41 PM
MWGWell....looks like some light sanding is in order!
Thanks!
May 07, 2017, 02:23 PM
MWGJust in case anyone is having similar issues...some light sanding on the rails and bottom lugs, voila like it was made for it!
Just test fit with the rails on the light only, not the locking lug...save you from having to disassemble the light