Do not like the sights on the P365 SAS. Need a recommendation for a replacement slide assembly with conventional iron sights, will re-use the original barrel. Not planning to add red-dot; optic compatibility is OK, but not required.

New or used is fine, would like to keep the cost down. Where should I look for this?

Complete factory slides are frequently seen on eBay around $300. But you can often find a better price for a used P365 factory slide on a gun classifieds forum, like the AR15.com Equiment Exchange or on GAFS.

Most quality aftermarket slides will cost you $350-$400+, nearly the same as a complete P365 for just a stripped slide, so if you're going for the cheapest option I wouldn't bother with those.

You could also just buy a new or used complete P365 for $400-$500 and then sell off your complete P365 SAS to recoup some/all of the cost.

If you look on GoinBroker there are a couple of vendors who part out 320s, 365s, etc. At least one has a website with component parts. I can't swear the prices will be better than elsewhere, but it's somewhere else to look.

quote:

Originally posted by V-Tail:
Do not like the sights on the P365 SAS. Need a recommendation for a replacement slide assembly with conventional iron sights, will re-use the original barrel. Not planning to add red-dot; optic compatibility is OK, but not required.

New or used is fine, would like to keep the cost down. Where should I look for this?

I'm in the same spot.

Sell it, buy what you want, is likely the cheapest option honestly.

V-Tail check your email

If you can find one, I think you should get one of these.



If you do a search on Gunbroker for P365 repair parts you might be able to find a deal. Here's one that went for $146 for all the parts except an FCU, including the slide and barrel.

Sig Sauer P365 9mm Repair Parts

SpinZone- email inbound

quote:

Originally posted by Paten:

If you can find one, I think you should get one of these.

Nice!