September 26, 2022, 06:53 PM
smittydogExpensive Friday
So, last Thursday I saw some YouTubes on new SIG 365X Macro comp. (Currently CC a Hellcat in summer) Woke up Friday morning and went to local GS before heading to work. Well, they had one…it was smooth. I liked it, I bought it. While they were writing it up, I laid my mitts on 320X custom works. Crap….. had to head to work. Luckily I got off work early and stopped by and picked it up. Again, expensive Friday.
September 26, 2022, 07:16 PM
.38supersigSeems familiar somehow...
Mine was a P226.
September 26, 2022, 07:33 PM
BasenjiI think you will love your Macro. The comp and the longer grip make followup shots much easier. I have a home made 320 Comp and love that with the red dot. I am thinking of getting a green dot for the Macro.
September 26, 2022, 07:54 PM
12131Expensive? That's why you went to work.
September 28, 2022, 08:08 PM
smittydogThat’s funny right there…
September 28, 2022, 08:32 PM
smittydogBoth the pistols shot well. The P365X Macro was very accurate and good follow up shots. The Spectre Comp though was an amazing shooter. Only issue is I am a bit disappointed in the finish (seams and mold injection points) of the lower. I guess I could lightly sand them to make the lines, etc, disappear. Anyone on here done that? I would assume so, guess I need to search.
Wasn’t comparing the two as they are for separate uses. SIG makes some good stuff.
September 29, 2022, 05:37 AM
Blume9mmhad the same sort of thing happen earlier this year... went to my LGS to pick up a Sig P250 in .380 I had bought from a fellow member here and on the way out glanced in one of the cases....
Sig P226 Legion in SAO...... even though it was used... it was less than a year old and did not look like it had even been fired..
September 29, 2022, 08:22 AM
Patenquote:
Originally posted by smittydog:
Both the pistols shot well. The P365X Macro was very accurate and good follow up shots. The Spectre Comp though was an amazing shooter. Only issue is I am a bit disappointed in the finish (seams and mold injection points) of the lower. I guess I could lightly sand them to make the lines, etc, disappear. Anyone on here done that? I would assume so, guess I need to search.
Wasn’t comparing the two as they are for separate uses. SIG makes some good stuff.
Go ahead and sand or file the grip module. Finish it with a finer grit sandpaper to remove the deeper scratches. That's the beauty of the modular system. It can be easily replaced if worn or damaged. You could also swap it out for a Wilson Combat grip module.