^^ Holsters may be a challenge. The slides tend to be shaped differently from those on Glocks.
When they say "Dagger magazine", has PSA started making or sourcing its own magazines? The pistols were supposed to have been designed around MagPul Glock magazines originally.
FWIW, I've got the original Glock 19-sized version, and MagPul mags have worked just fine so far.
ETA: There's a "holsters" section over on the PSA forum, FWTW.This message has been edited. Last edited by: Il Cattivo,
Posts: 27313 | Location: Deep in the heart of the brush country, and closing on that #&*%!?! roadrunner. Really. | Registered: February 05, 2008
Originally posted by Il Cattivo: When they say "Dagger magazine", has PSA started making or sourcing its own magazines? The pistols were supposed to have been designed around MagPul Glock magazines originally.
FWIW, I've got the original Glock 19-sized version, and MagPul mags have worked just fine so far.
This thread is about the Micro Dagger, a G43X clone. These are G43X clone magazines. Magpul does not currently make a magazine for the G43X. The Shield 15 round mags are of dubious quality with some good reports and some bad reports. Hopefully these PSA mags work good and will give G43X owners a reliable 15 round mag option.
The PSA mag is polymer on the front so no need to swap out the magazine release.
______________________________________________________ Often times a very small man can cast a very large shadow
Posts: 6712 | Location: Floriduh | Registered: October 16, 2004
PSA released the 15 round magazine today for the Micro Dagger/G43X/G48. It was on the website for 4 minutes before selling out. They will stagger out more mags over the weekend. Will be hard to get for a while. Let’s hope they are quality and work.
They have already released the Micro dagger (G43X ) slides in the past month and frames should be coming soon.
I have two mags incoming from PSA. $29.99 each.This message has been edited. Last edited by: bubbatime,
______________________________________________________ Often times a very small man can cast a very large shadow
Posts: 6712 | Location: Floriduh | Registered: October 16, 2004
Mags back in stock today at 4:17pm when I got the email. Was logged in at 4:11pm ordering a 5.7 for a customer and when I went to check the mags at 4:20, sold out.
Just got my 2 in today. I’m heading to the range tomorrow evening so I’ll try to post a report Thursday. They do seem solid and both lock the slide back. I can’t tell if it’s a 2 piece polymer and metal design or if it’s all metal with polymer on the front. My only worry is the 2 pieces separating after use. That is not based on anything other than a quick look and a possible issue.
Posts: 1537 | Location: Kentucky | Registered: December 05, 2011
My 3 should be here tomorrow. I just swapped a polymer mag release back in my 43X. We're planning on running these in my 43X and a coworker's older 43X (silver slide version).
