SIGforum
Do the Sig Romeo1 and the Trijicon RMR have the same mount?

This topic can be found at:
https://sigforum.com/eve/forums/a/tpc/f/430601935/m/4710003054

December 01, 2018, 10:23 AM
Valpo Fz
Do the Sig Romeo1 and the Trijicon RMR have the same mount?
I was looking at the Sig cal exchange kit vice having my slide milled and was wondering if they mounted the same way or used different holes?

Thanks
Ed


" The people shall have a right to bear arms, for the defense of themselves and the State" Art 1 Sec 32 Indiana State Constitution

YAT-YAS
December 01, 2018, 02:17 PM
apf383
I believe each optic has a proprietary mount or milling requirement for
the slide.



Foster's, Australian for Bud

December 01, 2018, 05:40 PM
Valpo Fz
Thanks, I think that answers my question.


" The people shall have a right to bear arms, for the defense of themselves and the State" Art 1 Sec 32 Indiana State Constitution

YAT-YAS
December 01, 2018, 05:53 PM
hrcjon
and as a practical matter all manner of people do the milling for an RMR, not so much the sig. And in any case the SIG is not very good, so don't do it...


“So in war, the way is to avoid what is strong, and strike at what is weak.”
December 01, 2018, 06:50 PM
Factor8
quote:
Originally posted by hrcjon:
and as a practical matter all manner of people do the milling for an RMR, not so much the sig. And in any case the SIG is not very good, so don't do it...


The romeo1 is not very good? Can you tell us about your personal experiences with the RX line? Razz

I have 3 RX's two 226's and one 320 and they have been flawless over the past 2 years of ownership. I also have a milled glock 19 with a RMR (RM06) and I have had nothing but flicker issues to the point I had to buy an anti flicker plate to make it work constantly. The Romeo1's have worked right out of the box as advertised.

So OP, if you are looking for the best bang for your buck it is hard to find a better deal than a RX X-change kit.

obligatory picture added Smile