January 18, 2024, 12:49 PM
GJM AKP320 XTen Comp introduced
My mags are marked "made in Italy," presumably by MecGar. Doing some researching I read if magazine problems after the 320 Ten was first introduced. I didn't have issues, although I used a loader and only loaded 14.
What's the word on the current mags?
May 13, 2024, 10:53 AM
AUTiger89Did anyone find an IWB holster for this? SIG CS says they don't have one available yet, and Crossbreed is dragging on this.
May 13, 2024, 11:55 AM
FP2000Hquote:
Originally posted by GJM AK:
I shot one today -- best shooting 10mm I have shot. Only one session, and 100 rounds but no issues. Ran 20 Underwood 200 hard cast, 20 Underwood Xtreme penetrators, 20 Cutting Edge 190 grain, and the rest S&B 180. Shot support hand only, limp wristing the Cutting Edge and hard cast loads, and couldn't induce a stoppage. The gun shoots very flat.
I mounted an EPS red fit with a CHPWS plate just now, and plan to do some more testing. The ballistics testing I saw, showed a 60 fps velocity loss over the five inch X Ten. For woods defense, which is close shooting, and closer yet on every successive shot, I think the velocity loss is a reasonable trade off for a compact, flat shooting pistol. A small comp makes a lot of sense on a 10mm, especially with a fast load like the Underwood Xtreme penetrator, which are advertised at 1,500 fps.
This is reassuring. I have my eye on this as a possible 10mm platform. I've heard about issues with the magazines with some of the loads you say you shot, so that's good news that you didn't have any issues. I would be wanting to run Underwood 200 grain hardcast in it, as well, so I'm glad you were able to test that.
August 29, 2024, 11:04 AM
AUTiger89I did find an IWB Kydex-Leather hybrid holster at Falcon Holsters. I ordered one but haven't received it yet.
Falcon Holster Hybrid Holster quote:
Originally posted by AUTiger89:
Did anyone find an IWB holster for this? SIG CS says they don't have one available yet, and Crossbreed is dragging on this.