Just about any good gunsmith can de-horn your SIG for you
However, if your firearm is anything but stainless, it will need to be refinished after the work is doneThis message has been edited. Last edited by: colt_saa,
Originally posted by Mustang-PaPa: Our very own CCR is your one stop shop for this. They will anti snag and refinish. The work and finishes are proven quality. Brad and Mary are the best. I also remember a members P225 that another refinisher screwed up that they took in and corrected that turned out very nice.
If you time if right you might even catch acsale on the refinishing.
______________________________________________ Life is short. It’s shorter with the wrong gun…
Posts: 13870 | Location: VIrtual | Registered: November 13, 2009
The edge of the hammer and the edge of the dovetail are so sharp it digs into my side. It digs in so much that carrying it ITW is not an option. Its the same with both my P938 and my P238. Really all I need is the hammer and frame honed down. The slide is no problems.
Posts: 24 | Location: Florida | Registered: December 06, 2019
