Strip finish / harsh solution for ultrasonic?

I've heard of nightmare 'lessons learned' of folks using the wrong product in their ultrasonic, removing the finish. But what if I wanted to intentionally strip off the finish? Is there an product a can use in my ultrasonic?

I want to strip a couple of older frames/slides (CZ 75 B & P228) down to the bare metal. Out of fear of potential regrets, I've only ever used a very mild soapy solution on my gun parts, so I'm not sure what I should use here.

Happiness is a warm gun.

Posts: 490 | Location: Shenandoah Valley | Registered: February 15, 2011

MikeinNC

semi-reformed sailor
Picture of MikeinNC

posted

Hide Post

Why would you want to remove the anodized finish?

"Violence, naked force, has settled more issues in history than has any other factor.” Robert A. Heinlein

“You may beat me, but you will never win.” sigmonkey-2020

“A single round of buckshot to the torso almost always results in an immediate change of behavior.” Chris Baker

Posts: 11524 | Location: Temple, Texas! | Registered: October 07, 2006