I managed to snag a Smith model 66 3" a while back. It has a set of Pachmeyer Compac Professional grips on it at the moment. It's such a nice looking wheel gun, I feel like it ought to have a more aesthetic set of stocks.
Thoughts?
Thanks!
Mike Smith/AAC
Mike Smith 404-213-7753
Posts: 565 | Location: Alpharetta, GA USA | Registered: January 27, 2003
I'm partial to Ahrend's grips, especially those with the tung oil finish. Top Gun Supply often has them in stock. That's where I usually buy mine. Ordering directly from Ahrends will give you a lot more wood choices but there's a long wait.
We the people are the rightful masters of both Congress and the courts, not to overthrow the Constitution but to overthrow the men who pervert the Constitution. Abraham Lincoln
When you pop open the cylinder, the model and generation are stamped on the frame, below the barrel.
Mine says 66-2.
As to grips, this 19 was in another thread, with factory Round-Butt target grips. They'd go great on yours, if you could find a pair:
-------------------------- Every normal man must be tempted, at times, to spit on his hands, hoist the black flag, and begin slitting throats. -- H L Mencken
I always prefer reality when I can figure out what it is. -- JALLEN 10/18/18
Posts: 9424 | Location: Illinois farm country | Registered: November 15, 2008
Agree with ‘bobandmikako’. Ahrends are nicest grips out there. Oiled. Reasonably priced. Got em on my 686. Boot grips or regular round butt. On 3 inch Barrel model 66. Maybe boot grips would be best way to go.
Posts: 31 | Location: Vidalia and Savannah Georgia | Registered: September 30, 2016