Posted this under Sig Armorer but....thought I'd try here too.

I have recently purchased a Sig P229 Emperor Scorpion 9mm as a carry gun. I would like to get it (besides the sights) to match my Legion P229 9mm as much as possible, which I also carry.

Since I had changed out the P229 Legion (GG) Trigger for the sig short reach trigger (small hands)....and the Scorpion already comes standard with that trigger....I believe the only thing left is the guide rod.

I want to carry and train with both pistols and want the transition between them to be as seamless in function as possible (again, besides the sights)...which brings me to my questions on the GG solid fat guide rods. Normally...I would simply buy an extra Legion 229 Guide Rod....but Sig will not sell the solid Legion Guide rod to the public. So...my questions:

1. What is the diameter difference between the two guide rods....standard vs gray guns fat rod? Can this cause any failure issues for a carry gun?

2. Does this diameter difference cause a problem with the original OEM springs? Is it a REALLY tight fit or does it slide on, pretty much, the same way as the OEM part?

3. Any resistance in the spring, guide rod mechanism during functioning (squeaking, scrapping, tightness, etc.)?

4. Have there been any issues in reliability in the P229 when switching over to the GG guide rods? Don't want to add an issue that does not exist.

5. ****I am ESPECIALLY concerned about FTE's (Failure to Extract/double feed) issues. CAN'T have this in a carry gun. **** Any problems with this?

I have those guide rods in all of my sigs. The springs go on a little snug but I have NEVER had any issues with reliability. Always ensure you put the spring on the correct way.

This message has been edited. Last edited by: whododat,

Thanks for the response Whododat.