SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    Caliber Conversion Question
Go
New
Find
Notify
Tools
Reply
  
Caliber Conversion Question Login/Join 
Member
posted
I have a 2007 made P229 in 40 cal. I recently saw Sig has a Pro-Cut Slide Assembly, Optic Ready.
https://www.sigsauer.com/p229-...tic-ready-black.html

I want to convert my P229 in 40 with this new slide and of course 9mm barrel and magazines.

My question is: Are the locking blocks the same? I understand that my P229 has the larger frame that would be equivalent to the newer P229-1 9mm models.

Anyone know for sure?
 
Posts: 970 | Location: Virginia | Registered: August 03, 2012Reply With QuoteReport This Post
Member
posted Hide Post
You could buy a conversion barrel, .40 to 9mm. Save some money, but the sights would probably be slightly off.


-c1steve
 
Posts: 4148 | Location: West coast | Registered: March 31, 2012Reply With QuoteReport This Post
Member
posted Hide Post
Steve, I could use a conversion barrel, but I do not want to....I want to use the Sig Pro-Cut Slide Assembly.
 
Posts: 970 | Location: Virginia | Registered: August 03, 2012Reply With QuoteReport This Post
Freethinker
Picture of sigfreund
posted Hide Post
quote:
Originally posted by Cousin Vinnie:
My question is: Are the locking blocks the same? I understand that my P229 has the larger frame that would be equivalent to the newer P229-1 9mm models.


The locking inserts of the 357/40 P229s and the older 9mm P229s are not the same. A conversion using the 357/40 slide and original locking insert is possible with a 9mm “conversion” barrel that’s designed to fit those parts.

I had never before tried the slide of my older 9mm P229 on a 357/40 P229 frame, but I did that just now and it fit fine.

The magazine well of the 357/40 P229 is wider than that of the original 9mm P229, and therefore older 9mm magazines are a loose fit. I have no experience with the P229-1 in 9mm, but believe you are correct. I also know nothing about the barrel and locking insert of the P229-1.




6.4/93.6
 
Posts: 47951 | Location: 10,150 Feet Above Sea Level in Colorado | Registered: April 04, 2002Reply With QuoteReport This Post
Member
posted Hide Post
There's a lot of info in this thread...
https://sigforum.com/eve/forum...935/m/5050009784/p/1

Your locking insert is the tall version... requires a shorter feed ramped barrel (Conversion barrel).

229 frames are the same size... however, the magwell opening is wider on the 229/40/357 & 229-1.

The question becomes what's the measurement between the bottom of the barrel and the top of the guide rod hole in the new pro cut slide?




 
Posts: 10062 | Registered: October 15, 2008Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    Caliber Conversion Question

© SIGforum 2024