SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Caulking Question - Expiration Date?
Go
New
Find
Notify
Tools
Reply
  
Caulking Question - Expiration Date? Login/Join 
Dances With
Tornados
posted
I have 5 tubes of caulk with expired dates.

There are 5 tubes, 3 Silicone and 2 Latex, according to the dates they are 1.5 to 2 years expired.

They were stored inside my home in a closet at normal temp.

I thought I’d try them out, then thought of the time required to prep first before using, thought better of it and thought I’d ask our resident experts here.

Are they bad or still good?

Throw out or go buy new?

Thank you.
 
Posts: 12031 | Location: Near Hooker Oklahoma, closer to Slapout Oklahoma | Registered: October 26, 2009Reply With QuoteReport This Post
Recondite Raider
Picture of lizardman_u
posted Hide Post
lay a small test bead on some scrap and see if it works still.

They may work as advertised, or the latex might be too dried out to work.

If the test bead works then use it.


__________________________
More blessed than I deserve.
http://davesphotography7055.zenfolio.com/f238091154
 
Posts: 3569 | Location: Boardman, Oregon | Registered: September 19, 2007Reply With QuoteReport This Post
A Grateful American
Picture of sigmonkey
posted Hide Post
^^^
Yep.

If it goos, it's good to use.




"the meaning of life, is to give life meaning" Ani Yehudi אני יהודי Le'olam lo shuv לעולם לא שוב!
 
Posts: 44595 | Location: ...... I am thrice divorced, and I live in a van DOWN BY THE RIVER!!! (in Arkansas) | Registered: December 20, 2008Reply With QuoteReport This Post
Dances With
Tornados
posted Hide Post
^^^^^ OK Oozey Usey. Thanks
 
Posts: 12031 | Location: Near Hooker Oklahoma, closer to Slapout Oklahoma | Registered: October 26, 2009Reply With QuoteReport This Post
Ammoholic
Picture of Skins2881
posted Hide Post
I'd throw it out and buy new. If I am dealing with something that would be a pain in the ass to strip off and recaulk at a later date, I rather pay the $7 a tube to make sure it lasts as long as possible.

They start reacting when exposed to air, but I don't know what kind of reactions are happening when sealed or if the seal is 100%, not worth risking to me. Now if it was something I could easily redo in the future then screw it, I'll try the expired stuff.



Jesse

Sic Semper Tyrannis
 
Posts: 21277 | Location: Loudoun County, Virginia | Registered: December 27, 2014Reply With QuoteReport This Post
Member
posted Hide Post
quote:
Originally posted by lizardman_u:
lay a small test bead on some scrap and see if it works still.

They may work as advertised, or the latex might be too dried out to work.

If the test bead works then use it.


This, you can also tell a lot of times by squeezing the unopened outside of the tube and seeing if the stuff inside is pliable or the plastic is hard as a rock and you can't squeeze/compress it at all.

I agree with Skins though, if it's something that's a pain to strip and redo, just buy new.
 
Posts: 21421 | Registered: June 12, 2005Reply With QuoteReport This Post
Not really from Vienna
Picture of arfmel
posted Hide Post
I’ve had siliconized acrylic caulk (Red Devil brand) that I used after it had expired fail to set up after being applied. I don’t recall the conditions it was stored in, but when I was dispensing it, it seemed to be ok.

I’d advise you to throw it away. I had a mess to clean up.
 
Posts: 27245 | Location: SW of Hovey, Texas | Registered: January 30, 2007Reply With QuoteReport This Post
Member
posted Hide Post
I think you should too any silicon. My experience is it will never dry
 
Posts: 1501 | Registered: November 07, 2013Reply With QuoteReport This Post
Member
posted Hide Post
quote:
Originally posted by oldbill123:
I think you should toss any silicon. My experience is it will never dry
 
Posts: 1501 | Registered: November 07, 2013Reply With QuoteReport This Post
Member
posted Hide Post
quote:
Originally posted by arfmel:
I’ve had siliconized acrylic caulk (Red Devil brand) that I used after it had expired fail to set up after being applied. I don’t recall the conditions it was stored in, but when I was dispensing it, it seemed to be ok.

I’d advise you to throw it away. I had a mess to clean up.


Yep, had a really old tube (unopened) of 100% silicon that I gave to a friend to use in a pinch. We were at a remote location and he needed a quick fix on a jetski. I don't think it ever completely set and was a gooey mess.
 
Posts: 2011 | Location: DFW Texas | Registered: March 13, 2012Reply With QuoteReport This Post
Certified All Positions
Picture of arcwelder
posted Hide Post
Ok.

Speaking as a professional with many years experience with caulk, I'll say this:

Go by the date on the tube.

After that, I judge it like a jewish grandma at the supermarket. Give it a squeeze. The tube will be very firm to outright hard if it is no good.

If what you are sealing is really important, don't use old caulk.


Arc.
______________________________
"Like a bitter weed, I'm a bad seed"- Johnny Cash
"I'm a loner, Dottie. A rebel." - Pee Wee Herman
Rode hard, put away wet. RIP JHM
"You're a junkyard dog." - Lupe Flores. RIP

 
Posts: 27124 | Location: On fire, off the shoulder of Orion | Registered: June 09, 2004Reply With QuoteReport This Post
Member
posted Hide Post
if what/where you are caulking is important forget it. if its not structural, not important, cosmetic, easy to fix etc. etc. go for it. But if you value your time above pennies an hour. just pitch it.


“So in war, the way is to avoid what is strong, and strike at what is weak.”
 
Posts: 11227 | Registered: October 14, 2004Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Caulking Question - Expiration Date?

© SIGforum 2024