Any Toyota owners have...Tundra OEM Center Console Safe 00016-34174
....and if you do, how did you install it on a double cab?
...You, higher mammal. Can you read? ....There's nothing sexier than a well worn, functional Sig!
May 10, 2020, 08:48 PM
alreadydead
Does your truck have the same center console?
__________________________ Keep your rotor in the green The aircraft in trim Your time over target short Make it count
May 10, 2020, 09:34 PM
BigJoe
quote:
Originally posted by alreadydead: Does your truck have the same center console?
It has the wide center console. The instructions indicate you have to yank out the rear double cup holders. I just don’t see why this has to be done.
...You, higher mammal. Can you read? ....There's nothing sexier than a well worn, functional Sig!
May 10, 2020, 10:41 PM
TannerBoyl
I don’t have that one, but I’ve installed a Console Vault inside of my 2012 Toyota Tundra Crewmax. It required me to remove a screw at the bottom of my center console which allowed my Console Vault to be screwed into the frame (or at least that’s what it said).
The toughest part for me was fitting the vault into the center console. It just slid right in, after I struggled for a bit.
May 11, 2020, 02:07 AM
1lowlife
They want you to remove the rear cup holder to remove the lid. Cupholder panel pops off, disconnect the 12v plug, remove the bolts that hold the lid on. Be careful because it is under spring tension.
I have a full Gunvault in my 2014 double cab. I've had it in and out a couple times and never have removed the cover to get the safe in and out.. Just go slow and slide it in. You should only have to remove the 2 bolts that hold the safe in. Just in case you do have to remove the lid, here is a video that will show you how. I used it to install my wireless charger.
they really isn't anything to it.
May 11, 2020, 04:45 AM
BigJoe
quote:
Originally posted by 1lowlife: They want you to remove the rear cup holder to remove the lid. Cupholder panel pops off, disconnect the 12v plug, remove the bolts that hold the lid on. Be careful because it is under spring tension.
I have a full Gunvault in my 2014 double cab. I've had it in and out a couple times and never have removed the cover to get the safe in and out.. Just go slow and slide it in. You should only have to remove the 2 bolts that hold the safe in. Just in case you do have to remove the lid, here is a video that will show you how. I used it to install my wireless charger.
they really isn't anything to it.
That video helped explain the removal of the lid.. Thanks a lot !
...You, higher mammal. Can you read? ....There's nothing sexier than a well worn, functional Sig!
May 12, 2020, 12:42 AM
1lowlife
quote:
Originally posted by BigJoe: That video helped explain the removal of the lid.. Thanks a lot !
Glad to help. Very happy to have a safe in the truck. . Did a little customization on mine..
.
