Finally got it in my hands.

One thing I don't like is the rear QD sling mount on the bottom of the stock. Has anyone added a QD mount somewhere on the side of the factory stock? I saw a video somewhere where it was talked about. If not I may have to go with the Magpul.

My 1301 also didn't fit in my rifle bag so I had to order a longer one for the range.

I don't use the OEM 1301 stock, but have a 12" Hogue Mossberg overmold stock with GGG Mossberg stock adaptor on my 1301 (same adaptor you need to use with the Magpul stock). I put a QD mlock sling mount cup on the side of the stock close to the buttpad by drilling two little holes for the mlock screws to go through into the Mlock nuts put inside the stock. No problems so far. The OEM stock is also hollow inside, so could be done the same as how I did it. You can buy the cheap QD sling swivel mlock parts for $10 on Amazon. You could also buy nicer than the China stuff, but I wanted to try it out to see if it would work before I committed to a more expensive higher-quality brand name. It works great, but since it aint failed yet, I haven't upgraded yet..

I have a Gen 1 LE 1301 I got in 2021. The LE version has a cylinder bore and no chokes. I have added:

- Gen 2 Aridus SGA stock adapter with buffer and Magpul SGA Stock
- Gen 2 Aridus Zhukov forend adapter.
- Aimpoint Acro on Scalarworks mount
- Nordic extension and clamp
- Aridus charging handle
- Beretta pro lifter - like on competition models - stays up higher and out of the way to make reloads easier.

I have the pistol grip stock, and it has the mount on the sides. (loop the sling through, not a QD or something sticking out.)