SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Heavy cleaning of Luxury vinyl plank flooring. I mean "heavy"
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
Heavy cleaning of Luxury vinyl plank flooring. I mean "heavy" Login/Join 
Green grass and
high tides
Picture of old rugged cross
posted
So this new construction house I have been overseeing the construction of has a floor cleaning issue I need some help on.
They used a good quality USA made LVP water resistant, not water proof product.
As the job has slowly progressed the flooring has been trekked on by many folks in and out of the home for at least 3 months. Not my idea. So it is not damaged, but damned dirty. A cursory cleaning did little to clean it. It could be damaged but think it just needs a good cleaning to bring it back. The builder has a mop bucket and think he is planning to mop it with water and some kind of a soap. Using lots of water seems like a bad idea. I am looking for a way to deep clean it. I need some first hand advice on how to clean it from months of construction dust and dirt. Suggestions? Thanks all.



"Practice like you want to play in the game"
 
Posts: 19950 | Registered: September 21, 2005Reply With QuoteReport This Post
Member
posted Hide Post
Is it a floating LVP or glued to a slab?
 
Posts: 9097 | Location: The Red part of Minnesota | Registered: October 06, 2002Reply With QuoteReport This Post
Green grass and
high tides
Picture of old rugged cross
posted Hide Post
floating



"Practice like you want to play in the game"
 
Posts: 19950 | Registered: September 21, 2005Reply With QuoteReport This Post
semi-reformed sailor
Picture of MikeinNC
posted Hide Post
We use a shark steamer for our LVP.

Once we moved in we found a lot of adhesive had seeped between the joints and I spent two days with a gallon of laquer thinner and a rag with the windows open to get rid of it



"Violence, naked force, has settled more issues in history than has any other factor.” Robert A. Heinlein

“You may beat me, but you will never win.” sigmonkey-2020

“A single round of buckshot to the torso almost always results in an immediate change of behavior.” Chris Baker
 
Posts: 11568 | Location: Temple, Texas! | Registered: October 07, 2006Reply With QuoteReport This Post
paradox in a box
Picture of frayedends
posted Hide Post
I can’t imagine if it’s that hard to clean that it isn’t scratched. Why wouldn’t they have put paper down over it while still doing construction? In any case hopefully you can clean it and it’s not damaged. If I was the home buyer I wouldn’t be happy.




These go to eleven.
 
Posts: 12605 | Location: Westminster, MA | Registered: November 14, 2006Reply With QuoteReport This Post
Green grass and
high tides
Picture of old rugged cross
posted Hide Post
Yep, Builder has done some really good things. But There are some real head scratchers too.

I do not think a steamer is going to do it for cleaning this type of situation.



"Practice like you want to play in the game"
 
Posts: 19950 | Registered: September 21, 2005Reply With QuoteReport This Post
Member
Picture of ShouldBFishin
posted Hide Post
We damp mop our floating LVP flooring - not heavy on the water.

When we had ours installed the manufacturer's information explicitly stated not to use a (Shark) steamer.
 
Posts: 1829 | Location: MN | Registered: March 29, 2009Reply With QuoteReport This Post
Member
posted Hide Post
I owned a flooring store for 35+ yrs.
We sold and installed LVP since it's inseption.
I would recommend using Armstrong's New Beginning. Directions
Do not flood the floor when using this product.
When you feel that the floor is clean, rinse the floor with Ammonia and water 1cup / gal water. Rinse water clean the floor is clean.
Buy 2 mops, 1 strip, 1 rinse. Using any soap product will leave a film. Soaps contain fats, fats are oil you don't want to do that.
Also, purchase the Armstrong at a flooring store not the grocerey or big box it's not the same.
Let the New Beginning work when applied.
 
Posts: 28 | Location: Fluid | Registered: January 20, 2018Reply With QuoteReport This Post
Thank you
Very little
Picture of HRK
posted Hide Post
Since construction is still going on and you clean it, you might insist the builder roll out some paper on the floors for protection.

Might ask the builder what his SOP is,

Here are some general instructions but it would be best to call the manufacturing company and find out what they suggest to clean it while maintaining the warranty on the floor.

The Link

LVP Care Guide

LVP flooring is manufactured for easy care, but there are a few important points to know before cleaning it.

Avoid using cleaners that contain ammonia, or mop-and-shine products that leave a film—this attracts soil

Stay away from liquid or paste wax, or commercial floor cleaners that are not labeled as safe for LVP flooring.

Choose mild cleaners like dishwashing liquid, diluted distilled white vinegar, or plain water.
The tools you select to remove dust and dirt should also be non-abrasive, like a microfiber wet/dry mop or a vacuum without a beater bar.
Never use steel wool or a stiff-bristled brush to scrub LVP flooring.
 
Posts: 24664 | Location: Gunshine State | Registered: November 07, 2008Reply With QuoteReport This Post
Fighting the good fight
Picture of RogueJSK
posted Hide Post
I wet mop my LVP floors, using water mixed with Armstrong vinyl floor cleaner. Just don't use a dripping wet mop and tons of water... wring it out most of the way before applying it to the floor.
 
Posts: 33443 | Location: Northwest Arkansas | Registered: January 06, 2008Reply With QuoteReport This Post
Savor the limelight
posted Hide Post
Sounds like new floor time to me. I’d call the flooring manufacturer and find out what they’d want you to do to preserve the warranty. How many years of life of the finish have been lost because the contractor didn’t pit paper down? Not a chance I’d clean it myself. The contractor owns this 100%.

Don’t pay the contractor until it’s right. Also, don’t pay the contractor until you’re sure all his subs and suppliers have been paid.
 
Posts: 11993 | Location: SWFL | Registered: October 10, 2007Reply With QuoteReport This Post
Void Where Prohibited
Picture of WaterburyBob
posted Hide Post
The contractor that installed my LVP flooring told me to use acetone to remove stubborn dirt and glue from it.
I questioned that, knowing acetone is a very powerful solvent and will dissolve some types of plastics.
He insisted, so I tried it and it works very well.

I would still test it on a scrap or in a place not readily visible.



"If Gun Control worked, Chicago would look like Mayberry, not Thunderdome" - Cam Edwards
 
Posts: 16723 | Location: Under the Boot of Tyranny in Connectistan | Registered: February 02, 2005Reply With QuoteReport This Post
Member
Picture of ridewv
posted Hide Post
I have little doubt that some damage in the form of scuffing and scratches was done to the LVP, hopefully it's minimal. Whoever scheduled it to be installed is responsible for the new flooring. The best way is to not schedule installation it until after all the trades are finished. But if trades are going to be permitted to work on the new flooring, it must be well covered to protect it.
That's water over the dam now, at this point it needs cleaned (even if that means said scuffs/scratches will be revealed). I'd use ammonia and water with a scrub brush (probably twice) then mop with clean water and dry. Avoid using abrasive pads which can slightly dull the area where used.


No car is as much fun to drive, as any motorcycle is to ride.
 
Posts: 7385 | Location: Northern WV | Registered: January 17, 2005Reply With QuoteReport This Post
Too soon old,
Too late smart
posted Hide Post
Couple of tips re LVP, having installed it a few years ago on our sunroom.

It's very absorbent. If you drop something on it even a drop of water, you've got to get it up quickly. If you don't notice it until the next day it's likely to leave a stain. What's worse is any food that may drop. A little spaghetti sauce that's unnoticed will leave its mark for a while depending on how quickly you get it off.


Imagine sitting watching TV or reading, relaxing with your shoes off. If your feet are the least bit moist, your footprint will be obvious on the floor. Again, it's highly absorbent. We make it a point of using either a footstool or recliner. Socks help but not foolproof.

If I were the owner I'd consider this as a gift. Get rid of the damaged floor (it's never going to look as new) and research LVP, lots of information.

It's just the wife and I, if our kids were still here along with their dog I dread to imagine the possibilities.

Wish we knew then what we know now. Too late now.


_______________________________________

NRA Life Member
Member Isaac Walton League

I wouldn't let anyone do to me what I've done to myself
 
Posts: 1512 | Location: NoVa | Registered: March 14, 2009Reply With QuoteReport This Post
Member
Picture of ridewv
posted Hide Post
quote:
Originally posted by RogB:
Couple of tips re LVP, having installed it a few years ago on our sunroom.

It's very absorbent. If you drop something on it even a drop of water, you've got to get it up quickly. If you don't notice it until the next day it's likely to leave a stain.....


Rog vinyl is not absorbent. But a liquid spill that that is left to evaporate will leave residue.


No car is as much fun to drive, as any motorcycle is to ride.
 
Posts: 7385 | Location: Northern WV | Registered: January 17, 2005Reply With QuoteReport This Post
Member
posted Hide Post
Am I the only one who finds the term "Luxury Vinyl Floor" a rather startling statement. Because Luxury it's not. It is actually a cheap imitation of a real hardwood floor and to be honest, CRAP. A good hardwood floor can last for centuries while a vinyl floor will start degrading at 10 years and require complete replacement in 20 years.


I've stopped counting.
 
Posts: 5783 | Location: Michigan | Registered: November 07, 2008Reply With QuoteReport This Post
Fighting the good fight
Picture of RogueJSK
posted Hide Post
It's "luxury vinyl" in comparison to the earlier generations of cheap vinyl flooring. Think rolls of linoleum, or similar. No, it's not hardwood, but it's a big step up in quality from those.
 
Posts: 33443 | Location: Northwest Arkansas | Registered: January 06, 2008Reply With QuoteReport This Post
Member
Picture of ridewv
posted Hide Post
Rogue has it correct. Yes it's not real wood but it is better than wood flooring in many ways. It's impervious to water, impervious to moisture from underneath, won't dent or scratch as easily, adds less thickness, and is generally easier to remove.


No car is as much fun to drive, as any motorcycle is to ride.
 
Posts: 7385 | Location: Northern WV | Registered: January 17, 2005Reply With QuoteReport This Post
Green grass and
high tides
Picture of old rugged cross
posted Hide Post
Peter 41692, Is this the right product to use on this LVP floor?

Thank you.


https://www.amazon.com/Armstro...sc=1#customerReviews



"Practice like you want to play in the game"
 
Posts: 19950 | Registered: September 21, 2005Reply With QuoteReport This Post
Ammoholic
Picture of Skins2881
posted Hide Post
quote:
Originally posted by old rugged cross:
Yep, Builder has done some really good things. But There are some real head scratchers too.

I do not think a steamer is going to do it for cleaning this type of situation.


You've answered your question already. If steam will not clean it, rip it out an relay it, it's ruined.



Jesse

Sic Semper Tyrannis
 
Posts: 21336 | Location: Loudoun County, Virginia | Registered: December 27, 2014Reply With QuoteReport This Post
  Powered by Social Strata Page 1 2  
 

SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Heavy cleaning of Luxury vinyl plank flooring. I mean "heavy"

© SIGforum 2024