SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Tool Junkies: Looking for a square punch
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
Tool Junkies: Looking for a square punch Login/Join 
mark_a
Move Up or
Move Over
posted Hide Post
quote:
Originally posted by mr.sig239:
Would these work? Not sure on the size though.
https://www.tool-rank.com/tool...e-holes-20100413655/


Better give Patrick-SP2022 some credit as he listed these first...

Check these guys out. Up in your part of the country as well...

Reynolda Cutting Tools
 
Posts: 4954 | Location: middle Tennessee | Registered: October 28, 2008Reply With QuoteReport This Post
PHPaul
Three Generations
of Service
Picture of PHPaul
posted Hide Post
quote:
Originally posted by mark_a:

Better give Patrick-SP2022 some credit as he listed these first...

Check these guys out. Up in your part of the country as well...



Oops, you're right. Two different links to the same tool. Missed that. Thanks, Patrick!



Be careful when following the masses. Sometimes the M is silent.
 
Posts: 15677 | Location: Downeast Maine | Registered: March 10, 2010Reply With QuoteReport This Post
9mmnut
Member
Picture of 9mmnut
posted Hide Post
The only one that will give satisfactory results are the one posted by sigmonkey. They support the underside of your material so no burrs and bent material.
 
Posts: 1195 | Location: Southern ,Mi. | Registered: October 17, 2011Reply With QuoteReport This Post
  Powered by Social Strata Page 1 2  
 

SIGforum.com    Main Page  Hop To Forum Categories  The Lounge    Tool Junkies: Looking for a square punch

© SIGforum 2024