April 10, 2023, 07:35 PM
Pb803365xl sight removal
Hello, I'm new here, and to Sigs.
I have a 365xl. I'm trying to remove the rear sight, to install a Holosun green dot.
I have not been able to get either screw to break loose, and, in fact may have stripped both screws.
I have removed the striker, and have slide ready for the vice.
Should I add heat to the screws, then try to remove...??
All comments are welcome,
Thank you,
Pb
April 11, 2023, 08:03 PM
Pete KHeat can help. I would put a soldering iron on each screw and get it good and hot before trying again.
April 11, 2023, 08:49 PM
Pb803Thanks for the reply.
I did that very thing, (soldering iron), and it did not help.
Off to a local gunsmith tomm.
Thanks
Pb