SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    Rear sights Sig Mosquito
Go
New
Find
Notify
Tools
Reply
  
Rear sights Sig Mosquito Login/Join 
ThankGod4Sig
SIGForum Official Hand Model
Picture of ThankGod4Sig
posted
Noticed today that my rear sight on my Mosquito was loose, it moved about 2 or 3 mm laterally.

I tried the small screw on the right side of the sight but all it did was turn.

Should I glue it down or send it to SIG?


"da evil Count Glockula."-Para
 
Posts: 7927 | Location: C-bus, Ohio | Registered: December 17, 2004Reply With QuoteReport This Post
SigSentry
Member
Picture of SigSentry
posted Hide Post
Not being familiar with the sight, the set screw may be stripped? You might call SIG to see if they will replace the sight. Or, you might try the blue loctite (non-permanent) to secure it.
 
Posts: 3638 | Registered: May 30, 2011Reply With QuoteReport This Post
stoic-one
Unflappable Enginerd
Picture of stoic-one
posted Hide Post
Are you saying the sight base itself is loose or just the sight aperture? The screw on the right side is for adjusting windage and can be stripped out by turning it too far.


__________________________________

NRA Benefactor
I lost all my weapons in a boating, umm, accident.
http://www.aufamily.com/forums/
 
Posts: 6384 | Location: Headland, AL | Registered: April 19, 2006Reply With QuoteReport This Post
ThankGod4Sig
SIGForum Official Hand Model
Picture of ThankGod4Sig
posted Hide Post
Rear sight is loose while in the sight groove.


"da evil Count Glockula."-Para
 
Posts: 7927 | Location: C-bus, Ohio | Registered: December 17, 2004Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    Rear sights Sig Mosquito

© SIGforum 2024