SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    DAK parts
Go
New
Find
Notify
Tools
Reply
  
DAK parts Login/Join 
Member
posted
To convert a Sig to dak you need a dak sear correct?
I have seen some kits for sale that do not have a dak sear as a included part.
 
Posts: 375 | Location: The once great state of California | Registered: November 05, 2006Reply With QuoteReport This Post
Freethinker
Picture of sigfreund
posted Hide Post
Sears in guns prior to the development of the DAK trigger would not work with the DAK system, but then the guns themselves had frames that were not compatible with DAK parts. Later all the sears were made to work in either DA/SA or DAK guns. I assume that’s still true despite the quiet smothering of DAK pistols in the SIG lineup, but I’m not positive.

This is a sear that will work in DAK guns. If the sear does not have the indentation on the one side, it won’t work.



This message has been edited. Last edited by: sigfreund,




6.4/93.6
___________
“We are Americans …. Together we have resisted the trap of appeasement, cynicism, and isolation that gives temptation to tyrants.”
— George H. W. Bush
 
Posts: 47852 | Location: 10,150 Feet Above Sea Level in Colorado | Registered: April 04, 2002Reply With QuoteReport This Post
Member
posted Hide Post
Thanks!
That explains it.
 
Posts: 375 | Location: The once great state of California | Registered: November 05, 2006Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    DAK parts

© SIGforum 2024