Has anybody got any experience with the P365 Mcarbo spring kit? I was thinking about installing it the same time as a factory flat trigger.
No, Google is not my friend.
July 04, 2021, 03:38 PM
Johnny 3eagles
Done on one of my P365s. Not difficult to install and slightly better trigger pull weight (by feel only). Can't hurt. I had previously installed the Sig Flat trigger, but replaced it with the GreyGuns flat trigger on both of my P365s.
Any dog can be a Guide Dog if you don't care where you're going.
NRA ENDOWMENT LIFE MEMBER
July 05, 2021, 10:26 AM
22940
I did go ahead and order the spring kit and trigger. Hope it turns out good.
No, Google is not my friend.
September 28, 2021, 12:32 PM
rmfnla
Be aware that that kit includes a lightened striker spring, and some users have experienced misfires with hard primers.This message has been edited. Last edited by: rmfnla,
***** Today, my jurisdiction ends here…
October 02, 2021, 04:20 AM
JDG
Mcarbo mag springs fixed a plagued Rem 597 that flat out would not run! Great company to deal with. Good luck with your project, hope you get the results I did!
October 03, 2021, 12:18 AM
YooperSigs
MCarbo did the trigger work on my P-07. Excellent work!
End of Earth: 2 Miles Upper Peninsula: 4 Miles
October 05, 2021, 11:27 PM
Rick Lee
I put it in my P365 along with the factory flat trigger. I got some light primer strikes, so I put the stock striker spring back in. It runs like a top now, great shooter and great trigger. Thousands of rounds through her and not a hiccup.