Does anyone know where I can order and purchase a Barrel Shroud for the full length of the exposed barrel of my Keltec CMR30 rifle ??? Many that I have seen online are only about 4 or 5 inches long. I need one about 8 to 8.5 inches long. Thank you for reading and any info given. God Bless !!!

I found this one at Midway.

https://www.midwayusa.com/product/1021695495

Tag - I'm looking for solutions as well. Been eyeing this one but haven't purchased yet. They make a variety of fake cans so they may have longer versions.

AAC Style Barrel Shroud



.-.-.-.

This message has been edited. Last edited by: m499,

Don't own one. I had been looking at shrouds for a project, and had that one archived. It was the only one in the length specs.

quote:

Originally posted by m499:
Tag - I'm looking for solutions as well. Been eyeing this one but haven't purchased yet. They make a variety of fake cans so they may have longer versions.

AAC Style Barrel Shroud



.-.-.-.

Thanks; however from my measurements theirs are about 3/4 inch too short. God Bless !!!

Shrouds are cool, but make sure and get the shoulder thing that goes up. Killer...

I have an old faux can from a Beretta storm carbine, slips over barrel and tightens down with set screws, only 6.25" long though.

I finally got my Barrel shroud cut to size. Every gunsmith I went to told me they could not do it. Finally I found a machine shop that did it in less than 15 minutes for $10. Currently it has a cheap 150 lumen flashlight which I plan on upgrading in the near future. Here it is. I think it looks great. God Bless !!!

The best looking piece that I’ve seen for the CMR is the haha forend extension..

OOS right now, but I plan on getting one of these for mine eventually.

https://hagadefense.com/cmr-30-m-lok-handguard/