As fans of the CZ-452 rimfire series know, the rifle cocks upon raising the bolt handle. With one of my 452's however, a tiny amount of rearward bolt movement must occur before the sear and trigger fully engage. This is confirmed by an audible click as well as being visually observable with the action removed from the stock. (With both of my other 452's, the sear and trigger engage at the instant the bolt is raised.) Is this cause for alarm? I've considered sending it to CZ for a look though I don't want to spin my wheels if it within specifications. Thank you in advance for your thoughts.
Update - After contacting CZ USA Technical Support, they requested I return the rifle for evaluation. Apparently the bolt handle was out of spec. With the handle replaced, the rifle was checked for proper headspace, test fired and returned to me in 12 days with all issues resolved. High marks for CZ Service.This message has been edited. Last edited by: hjs157,
Posts: 2657 | Location: Western PA | Registered: July 20, 2010
I certainly wouldn't bother to go to expense to adjust it. The rifle works properly it just requires a, as you said, tiny amount of rearward bolt travel to reset. The bolt must travel rearward to pick up the next round.
Posts: 13483 | Location: The Edge of the Ozarks | Registered: December 04, 2003