SIGforum.com    Main Page  Hop To Forum Categories  Mason's Rifle Room    Minimum tools needed to build an AR lower
Page 1 2 
Go
New
Find
Notify
Tools
Reply
  
Minimum tools needed to build an AR lower Login/Join 
hrcjon
Member
posted Hide Post
quote:
by all means buy a staking tool.

I have seen special tools for staking the bolt carrier screws, but I can't imagine what exactly a staking tool would be for the castle nut. Of course a center punch is perfectly adequate as you note, but what special tool is there?


“So in war, the way is to avoid what is strong, and strike at what is weak.”
 
Posts: 10996 | Registered: October 14, 2004Reply With QuoteReport This Post
gearhounds
Wait, what?
Picture of gearhounds
posted Hide Post
quote:
Originally posted by hrcjon:
quote:
by all means buy a staking tool.

I have seen special tools for staking the bolt carrier screws, but I can't imagine what exactly a staking tool would be for the castle nut. Of course a center punch is perfectly adequate as you note, but what special tool is there?


Some folks use a spring loaded center punch or something specific for the job. I was surprised how little force is required to deform the end plate adequately.



“Remember to get vaccinated or a vaccinated person might get sick from a virus they got vaccinated against because you’re not vaccinated.” - author unknown
 
Posts: 15561 | Location: Martinsburg WV | Registered: April 02, 2011Reply With QuoteReport This Post
burnetma
Member
posted Hide Post
Nobody told you the most important tool: a thick wallet. Assemblying ARs is addictive. I just wanted to build a 6.8 SPC rifle, because I wanted to understand function and get all of the features I wanted for under $1500. One became four and counting.
 
Posts: 2033 | Location: Virginia | Registered: April 08, 2012Reply With QuoteReport This Post
  Powered by Social Strata Page 1 2  
 

SIGforum.com    Main Page  Hop To Forum Categories  Mason's Rifle Room    Minimum tools needed to build an AR lower

© SIGforum 2024