Sig P320 Slide Miling

December 01, 2019, 09:59 AM

rockchalk06

Would like to get SF's opinion on slide milling.

I have a P320 X-Compact and really love the weapon. So much so, that I had Nightingale Leather make me a Griffon OWB w/ TLR-7 and cut for an MRDS. My options stock are the Romeo1Pro or DPP. Delta sits too high for my liking and the durability of the Sig Optics, leave much to be desired. I also refuse to carry a MRDS without back up irons.

I can go with a Springer mount that includes the dovetail for a rear suppressor sight, but again, the height has me on hold.

My other option would be to have a slide milled. I have a post P320 SC that I could use to donate the slide to this project or just purchase another one and have it milled. That said, who does the forum recommend for this? MRDS would be an RMR 06 3.25 MOA Type 2.

Last question, I have seen a few custom slides on the net. I've always been cautious of aftermarket stuff on a carry weapon. Is there a company that makes a reliable aftermarket slide milled already that can be trusted?

Thanks SF

December 01, 2019, 11:44 AM

Battlecloth

quote:
Originally posted by rockchalk06:
Would like to get SF's opinion on slide milling.

I have a P320 X-Compact and really love the weapon. So much so, that I had Nightingale Leather make me a Griffon OWB w/ TLR-7 and cut for an MRDS. My options stock are the Romeo1Pro or DPP. Delta sits too high for my liking and the durability of the Sig Optics, leave much to be desired. I also refuse to carry a MRDS without back up irons.

I can go with a Springer mount that includes the dovetail for a rear suppressor sight, but again, the height has me on hold.

My other option would be to have a slide milled. I have a post P320 SC that I could use to donate the slide to this project or just purchase another one and have it milled. That said, who does the forum recommend for this? MRDS would be an RMR 06 3.25 MOA Type 2.

Last question, I have seen a few custom slides on the net. I've always been cautious of aftermarket stuff on a carry weapon. Is there a company that makes a reliable aftermarket slide milled already that can be trusted?

Thanks SF

I had Jagerwerks do the work for my P320 PDW (RMR 06 3.25 MOA Type 2). The mill work was perfect but I did need to send it back for a finish issue. They took care of it and the end result is about as good as it gets, IMO. I would use them again.

http://jagerwerks.com/sig-s/