Is replacing a 365 Trigger similar to replacing a 320 Trigger? I haven’t taken a good look at the 365 FCU yet.

quote:

Originally posted by dc54:
Is replacing a 365 Trigger similar to replacing a 320 Trigger? I haven’t taken a good look at the 365 FCU yet.

Same question I had. I've replaced both 320 triggers, but that's the full extent of my smithing experience, and I'm not interested in getting much more skilled than that.

quote:

Originally posted by TheMan:

quote:

Originally posted by dc54:
Is replacing a 365 Trigger similar to replacing a 320 Trigger? I haven’t taken a good look at the 365 FCU yet.

Same question I had. I've replaced both 320 triggers, but that's the full extent of my smithing experience, and I'm not interested in getting much more skilled than that.

there are videos already out there.
I hear that it is only marginally harder than swapping out 320 trigger. Of course, your mileage may vary.

When are the pre-orders going to be shipped?

quote:

Originally posted by Anush:
When are the pre-orders going to be shipped?

Later this week.
Machining of the first run has been done already done for over a week.
We had a delay as our normal Nitride facility has to have their furnace
replaced, so we had to ship the triggers out to another facility.
(Appreciating everyone's patience)