Sigurd Short Stroke Trigger for the LCP II

April 17, 2019, 07:51 AM

Sunset_Va

quote:
Originally posted by GallowayPrecision:
quote:
Originally posted by Sunset_Va:
Gunsmith forgot to re-install the slide release lever.
Didn't forget anything, it's off being 3D scanned for parts development.

Goody, more upgrades for me to order for my neat little Ruger ! The factory slide release is near impossible to use.

I ordered the Sigurd trigger, hopefully will have it installed soon. One small irritation with my LCP II, is the trigger stings my finger after 20+ rounds.
Not a painful sting, but noticable. I hope the Sigurd trigger eliminates that.

4.19.19 update

I received the Sigurd trigger for my LCPII yesterday and installed it. Installation was easy, and the quality of the trigger was excellent.

However..the execution of the design, in my case is flawed. You have to position your trigger finger at the very bottom of the trigger to engage the blade safety and pull the trigger.

This is not good.

Repeated attempts to quickly pull the trigger by just drawing and pulling the trigger, resultrd in no fires. I tried it at first with a safe gun , each time I had to reposition my finger (lower) to pull the trigger. This could be fatal in a self defense situation.

I also live fired (50 rounds) of ammo , testing this trigger, and really didn't notice any shorter reset than the original trigger. And also, I still had to reposition my finger lower on the trigger to pull through.

I thought perhaps having smaller fingers caused this, so I tried firing it with gloves, with the same result. I cannot endorse this trigger due to this fault, perhaps it is my particular made unit? And will be reinstalling my original Ruger trigger.

If Galloway Precision reads this, I would like their feedback , on how to correct this serious problem, please understand I am just passing on my experience with this product.

This message has been edited. Last edited by: Sunset_Va,

May 14, 2019, 09:12 AM

GallowayPrecision

quote:
Originally posted by Sunset_Va:
quote:
Originally posted by GallowayPrecision:
quote:
Originally posted by Sunset_Va:
Gunsmith forgot to re-install the slide release lever.
Didn't forget anything, it's off being 3D scanned for parts development.

Goody, more upgrades for me to order for my neat little Ruger ! The factory slide release is near impossible to use.

I ordered the Sigurd trigger, hopefully will have it installed soon. One small irritation with my LCP II, is the trigger stings my finger after 20+ rounds.
Not a painful sting, but noticable. I hope the Sigurd trigger eliminates that.

4.19.19 update

I received the Sigurd trigger for my LCPII yesterday and installed it. Installation was easy, and the quality of the trigger was excellent.

However..the execution of the design, in my case is flawed. You have to position your trigger finger at the very bottom of the trigger to engage the blade safety and pull the trigger.

This is not good.

Repeated attempts to quickly pull the trigger by just drawing and pulling the trigger, resultrd in no fires. I tried it at first with a safe gun , each time I had to reposition my finger (lower) to pull the trigger. This could be fatal in a self defense situation.

I also live fired (50 rounds) of ammo , testing this trigger, and really didn't notice any shorter reset than the original trigger. And also, I still had to reposition my finger lower on the trigger to pull through.

I thought perhaps having smaller fingers caused this, so I tried firing it with gloves, with the same result. I cannot endorse this trigger due to this fault, perhaps it is my particular made unit? And will be reinstalling my original Ruger trigger.

If Galloway Precision reads this, I would like their feedback , on how to correct this serious problem, please understand I am just passing on my experience with this product.

Email me at tech@gallowayprecision.com