September 09, 2019, 03:42 PM
Johnny 3eaglesModified my Sig P365 MS
I finished my additions to my P365 MS today. TFO front sight previously installed, added the Sig Flat Trigger, and the GreyGuns Laser-Sculpted Grip Module. The Grip Module had to be modified to receive the FCU for a manual safety and took about 15 minutes to trim and fit.
September 09, 2019, 03:59 PM
pm9Nice job. I love the flat trigger in my gun.
September 11, 2019, 07:48 PM
Sig DaleLooks great. How did you fit/trim the safety slot ?
September 11, 2019, 11:18 PM
Johnny 3eaglesI used an Xacto knife, cut to the rough size, then my very small files to final size. The polymer grip module is easily cut with a sharp thin blade.
Just a short note: my old P365 grip module has some markings inside showing a future location for the safety cutouts, but the sculpted module did not have the marks, so I had to use my factory manual safety module to make my initial marks. I aligned to two modules by placing a thin punch through the pin hole for the FCU pin.