SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    p250 slide milling/customization?

Moderators: Chris Orndorff, LDD
Go
New
Find
Notify
Tools
Reply
  
p250 slide milling/customization? Login/Join 
Member
Picture of kokopelli
posted
I’d like to get some of the thickness of my p250 subcompact’s slide taken down, sort of what the 320looks like...
Any recommendations, experiences?


_____________________________
God Rocks!
 
Posts: 246 | Registered: September 08, 2009Reply With QuoteReport This Post
Member
posted Hide Post
I understand that you like the looks of the P320's slide; it is attractive.

I am not certain I understand the thickness issue. In the photo below, the yellow line on the P250's slide duplicates the bottom of the angled cut on the upper part of the P320's slide. If you were the duplicate the P320's upper angle cut on the P250, the only metal you would remove would be above the yellow line and nearly entirely behind the ejection port.


 
Posts: 604 | Location: North Carolina | Registered: March 25, 2005Reply With QuoteReport This Post
Member
Picture of kokopelli
posted Hide Post
I see your point...I guess it would take a little more aggressive removal, but that's basically what I'm wanting to do.


_____________________________
God Rocks!
 
Posts: 246 | Registered: September 08, 2009Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Pistols    p250 slide milling/customization?

© SIGforum 2019