To adapt an Octane 45K to 11/16"-24 threaded barrel?

This topic can be found at:

August 01, 2020, 06:50 AM
To adapt an Octane 45K to 11/16"-24 threaded barrel?
Apparently, 11/16"-24 is a less common threading pattern.

Silencerco's Alpha direct thread mounts don't list one.

Are there any other sources of a direct thread 11/16"-24 mount that will fit my Octane 45K ?

August 01, 2020, 01:29 PM
What gun is it for ??

A quality thread adapter will probably be your best bet. Rocksett it onto your barrel and torque down to 30 ft/lbs:
August 01, 2020, 01:39 PM
A direct thread mount or piston mount made for the Octane would be the best option (probably not available). If that is not possible then a quality adapter would work. I have a couple of adapters from TROS in Oregon The make good quality stuff.
I’m curious what gun and caliber uses the 11/16”x24 thread pattern?
August 02, 2020, 12:38 AM
Ruger 77/44

August 02, 2020, 12:57 AM
George from Alaska
I second TROS. He has made a couple if things for me over the years that worked perfectly.

P220 European
P220 Scorpion
P220 10mm Legion
P226 Legion
P226 SAO Legion
P229 Legion
556 rifle, my favorite 556
P320 M17 (not the expensive
one) with Leupold DPP
P227 Tac-ops
August 02, 2020, 04:53 AM
Might want to check here as well...

I haven't personally used him, but from what I've seen on a couple of other forums he's good to go. I didn't see your necessary thread pitch listed, but they offer a custom threading option.
August 02, 2020, 07:59 AM
TROS has been my usual go to thread adapter--no love for the 11/16 oddball tread.

My new go to for thread adapters is Hughes.
11/16 in stock.
August 11, 2020, 12:56 PM
Thanks for the suggestions, guys.