The other ad was starting to run long so I thought I would start a new one. Here are a few of the guns I have coated for members here and a few others I have done lately. Complete pistol One color $90 Two tone. $100 Frames $65 Slides $45 Barreled action $125 includes bottom metal Shotgun. $100 prices do not include return shipping
I do coat mags. It depends on what kind of mag. I usually get $10 per mag but I do give a discount for multiple mags. Price gets better as the quantity goes up. I have done as many as 50, 30rd AR mags at one time. What are you wanting done?
CoyoteKiller just completed a 1022 barrel, receiver and one piece scope mount for me. His workmanship is excellent and he's a good guy to deal with. I recommend him. Another good point is that he is an FFL so shipping and receiving serial numbered items is easy. I'll try to remember to post photos when I get some.
Edit to add photo. Your results will be as good as your preparation. I did the prep on these parts. I'll take credit for the small scratch on the lower part of the receiver.
This message has been edited. Last edited by: Bill40718,
I have commented in this before but will be glad to again. I do not like durakote at all. Moly resin and ceracoat are both very good coatings that I don't think you can go wrong with either one. I prefer the moly because it has a smoother finish than ceracoat and is Teflon based instead of ceramic based so I just gets smoother inside actions and moving parts as it is used. I would be glad to do the glock slide for you. Just e sure whomever you use replaces the firing pin liner after curing as the heat will ruin it. I do keep them in stock.
I do coat the revolvers. I do not require any prep work or disassembly by you unless you just want to do it. Send the gun to me, I will tear it completely down, media blast, coat, lube and reassemble for you.
Do you have a website or an order form. Thanks. I have an older Browning hi- power with a little pitting and most of the bluing is gone, please send me some info.
NRA Life Member, FFL, 2-P228's, S&W Model 39, S&W Model 19 - .357/.38 4 inch hard chrome, Glock 26, Browning Hi Power, Colt Sporter HBAR, Winchester Model 94 Cowboy 16", .357/.38, Springfield Armory XDM9 Sub Compact
Posts: 23 | Location: Chandler | Registered: September 16, 2009
Bump for Coyote's business, as some one that has done Moly Resin for personal and profit,his work looks excellent and for the work involved, dissassembly , prep and finish , his price is very reasonable.
Posts: 4110 | Location: Near the Metropolis of Tightsqueeze, Va | Registered: February 18, 2007
Coyote did a Colt revolver in OD green for me a few months ago and it came out beautiful. I wanted to post pic's but having trouble doing that. Coyote was patient with all my questions and again, work was excellent. I will be using him again in the future. Doug, sorry it has taken me so long to get this thank you posted. Thanks again
'I am the danger'...Hiesenberg 2013 R.I.P. NRA Life Member I.A.L.E.F.I. Member
I just want to say "Thank you" for the refinish job on my Springfield 1911. You did an excellent refinish job and thank you for following the instructions for the compensator, it turned out the way I hoped it would...
If you are on the fence about using coyotekiller? Jump off and give him a shot!
Good Luck Doug sig-onslaught
Posts: 1057 | Location: 3 Doors Down | Registered: August 24, 2005